3ph Help
IHcubman
Join Date: Jul 2003 Posts: 26 Warren, MA |
2002-08-15 41274
I just bought a new Massey Ferguson 1433V compact tractor with a rotary cutter on the back. My problem is the top link and lift arm leveling assembly keep coming loose. The little rods welded to the check nut and the turnbuckle section really doesn’t give enough leverage to tighten them up very good. I have tried tightening the check nut with a wrench while putting a tube on the turnbuckle to get extra leverage, but the nut and turnbuckle still loosen up over time. I also tried wrapping a bungee cord around the two, but to no avail. My friend suggested that the surface of the nut might not be flat enough to bind tightly to the turnbuckle body. Are there any suggestions that might help me out? Has anyone else had this problem? It is very discouraging. I can tighten the two together, go mowing, and after a while I’ll notice the right front edge of the cutter digging in. Sure enough, I’ll bring it back to the barn on the level floor and find the leveling adjustment (I only have adjustment on the right side) will have moved. The check nut and turnbuckle may still be tight against each other, but they have moved together. Help!
Reply to | Quote Reply | Add Photo
3ph Help
MRETHICS
Join Date: Jul 2003 Posts: 190 Star City, Indiana |
2002-08-16 41311
Other than an adhisive (locktite).I dunno.............
How much vibration is that cutter making?
Or do you have a slow leak in the rear tire on the same side?? ....
Reply to | Quote Reply | Add Photo
Go Top
Share This